- 熱工儀表
- 壓力儀表
- 流量儀表
- 物位儀表
- 轉速儀表
- 調節閥門
- 執行機構
- 智能顯示
- 信號隔離
- 儀表盤柜
- 儀表電纜
- 儀表配件
- 電流電壓
- 進口儀表
- 倍西儀表

| 相序控制器
Phase Sequence Indicator
特性 Characteristics ·用于三相電網的相序自動控制Auto-control of phase sequence for three phase network ·環境溫度Ambient temperature range: -25℃ to+55℃ ·外殼防護Housing protection:IP42 ·耐振動Vibration strength:0.7g ·工作電壓(相一相)Voltage(Phase to phase): 380Vac±20% 440Vac±10% ·頻率Frequency:50…60HZ ·電源消耗power consumption:≤4VA
產品分類Table
使用說明Directions User should properly connect according to figure I while using Theis product. 2、當接入相線為正序時,批示燈亮點按順時針旋轉,同時正序繼電器延時吸合,反之,則指示燈亮點接逆序時針旋轉,同時逆序繼電器延時吸合,兩繼電器有電氣連鎖。 The lamp will sequence turn on clockwise when the connect power is RF correct,meanwhile relay of RF correct will close,otherwise the lamp will sequcnce turn on anticlockwise while the RF false relay will be close,two relay are electrical connected. 3、當接通電源后,各相所對應的指示燈點亮,如有缺相時對應此相的指示燈會熄滅,且指示燈亮點停止旋轉,同時原吸合繼電器延時釋放,從而使兩繼電器都處于釋放狀態。 After connecting to the power,the phase-indicated-lamp should be rurn on,if one phase loses,then responded lamp will be off,and sequence lamp will stop work and the relay will open,and two relay all in open status.
|











